LAN91C96

10Based-T Ethernet Controller

制造商:

产品信息

Please consider this device


The LAN91C96 is a VLSI Ethernet Controller that combines Local Bus, PCMCIA, and Motorola 68000 bus interfaces in one chip. LAN91C96 integrates all MAC and physical layer functions, as well as the packet RAM, needed to implement a high performance 10BASE-T (twisted pair) node. For 10BASE5 (thick coax), 10BASE2 (thin coax), and 10BASE-F (fiber) implementations, the LAN91C96 interfaces to external transceivers via the provided AUI port. Only one additional IC is required for most applications. The LAN91C96 comes with Full Duplex Switched Ethernet (FDSWE) support allowing the controller to provide much higher throughput. 6K bytes of RAM is provided to support enhanced throughput and compensate for any increased system service latencies. The controller implements multiple advanced power-down modes including Magic Packet to conserve power and operate more efficiently. The LAN91C96 can directly interface with the Local Bus, PCMCIA, and 68000 buses and deliver no-wait-state operation.


*Theservice is subject to Microchip'sand requires a myMicrochip account.

 

Features

  Non-PCI Single-Chip Ethernet Controller

  A Subset of Motorola 6800 Bus Interface Support

  Fully Supports Full Duplex Switched Ethernet

  Supports Enhanced Transmit Queue Management

  6K Bytes of On-Chip RAM

  Supports IEEE 802.3 (ANSI 8802-3) Ethernet Standards

  Automatic Detection of TX/RX Polarity Reversal

  Enhanced Power Management Features

  Supports "Magic Packet" Power Management Technology

  Hardware Memory Management Unit

  Optional Configuration via Serial EEPROM Interface (Jumperless)

  Supports Single +5V or +3.3V (for Revisions E and Later) VCC Design

  Supports Mixed Voltage External PHY Designs

  Low Power CMOS Design

  100 Pin QFP and TQFP (1.0mm Body Thickness) RoHS Compliant Packages

  Pin Compatible with the LAN91C92 and LAN91C94

Bus Interface

  Direct Interface to Local Bus, PCMCIA, and 68000 Buses with No Wait States

  Flexible Bus Interface

  16 Bit Data and Control Paths

  Fast Access Time

  Pipelined Data Path

  Handles Block Word Transfers for Any Alignment

  High Performance Chained ("Back-to-Back") Transmit and Receive

  Pin Compatible with the LAN91C92 (in Local Bus Mode) and the LAN91C94 in Both Local Bus and PCMCIA Modes

  Dynamic Memory Allocation Between Transmit and Receive

  Flat Memory Structure for Low CPU Overhead

  Buffered Architecture, Insensitive to Bus Latencies (No Overruns/Underruns)

  Supports Boot PROM for Diskless Local Bus Applications

Network Interface

  Integrated 10BASE-T Transceiver Functions:

  Driver and Receiver

  Link Integrity Test

  Receive Polarity Detection and Correction

  Integrated AUI Interface

  10 Mb/s Manchester Encoding/Decoding and Clock Recovery

  Automatic Retransmission, Bad Packet Rejection, and Transmit Padding

  External and Internal Loopback Modes

  Four Direct Driven LED Outputs for Status/Diagnostics

Software Drivers

  LAN9000 Drivers for Major Network Operating Systems Utilizing Local Bus or PCMCIA Interface

  Software Drivers Compatible with the LAN91C92, LAN91C94, LAN91C100FD (100 Mb/s), and LAN91C110 (100 Mb/s) Controllers in Local Bus Mode

  Software Drivers Utilize Full Capability of 32 Bit Microprocessor

{popup:id=271;timer=86400}

    LAN91C96封装图

    在线购买

    应用案例